Table of Contents
Advertisement
120 Configure an E1/T1 card
Procedure 46
Configuring basic parameters for an E1/T1 card through the Web
Step
1
2
3
4
5
Media Gateway 1000E PRI Gateway Installation and Commissioning
Action
On the Home - System Overview screen, select System
Settings > Basic Setting.
The window shown in
Settings window" (page 120)
Figure 33
System Settings - Basic Settings window
The IP address was previously defined through a CLI command
as shown in
"Configure LAN parameters" (page
In the MGC IP address field, type the IP address of the Media
Gateway Controller.
The E1/T1 card uses this address to receive the time and date
from the Media Gateway Controller.
In the System Name field, type up to 15 alphanumeric
characters for the name of the system.
In the IP address of E-mail Server field, type the IP address.
The E1/T1 card uses this address to send system backup files.
If this field is left empty or is incorrect, the E1/T1 card does
not send e-mail messages. However, the rest of the system
operates properly.
ATTENTION
The E1/T1 card uses SMTP. The e-mail server must support this
protocol.
In the From E-mail address field, type the e-mail address
that the E1/T1 card uses to identify itself (the default is
MGP@company.com). This is the e-mail address that appears in
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Figure 33 "System Settings - Basic
appears.
108).
Advertisement
Table of Contents
