Nortel 1000E PRI Installation And Commissioning Manual page 88

88 Configure an E1/T1 card
For CTYP=MSDL configuration, CS 1000 software is flexible. An E1/T1
span can use port 0 or port 1 of the DDCH along with MG_CARD prompt
added to support the Media Gateway Controller (MGC).
Backup D-channels are supported. Use the CLI to configure backup
D-channels in the same manner as the primary D-channels.
ATTENTION
For the PRI Gateway, the following software package for the functionality that
allows the use of port 0 or port 1 is provided in CS 1000 Extended Media
Gateway PRI (MGP) package 418
For the PRI Gateway, digital trunk loop and D-channel configuration is not
supported on TMDI card types.
nB+D PRI is supported by the PRI Gateway but is not shown in these
examples. For more information about configuring nB+D PRI, see ISDN
Primary Rate Interface Features Fundamentals (NN43001-569-B1).
Use
using LD 17" (page 88)
the PRI Gateway.
Procedure 19
Configuring a D-channel interface to support PRI/NI2 using LD 17
Step
1
2
3
Table 19
PRI/NI2 D-channel interface configuration (LD 17)
Prompt Response
REQ CHG
TYPE ADAN
ADAN NEW DCH xx
CTYP MSDL
Media Gateway 1000E PRI Gateway Installation and Commissioning
Procedure 19 "Configuring a D-channel interface to support PRI/NI2
to configure the PRI/NI2 D-channel interface in
Action
Log on to the CS 1000E.
To access LD 17, enter:
LD 17
Enter the responses shown in
interface configuration (LD 17)" (page
Description
Change existing data.
Action device and number.
Add a D-channel on logical port 0 - 254.
D-channel configuration on MSDL card.
MSDL= NTBK51AA/NTBK51CA downloadable D-channel
daughterboard.
TMDI is not supported for MGP.
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Table 19 "PRI/NI2 D-channel
88).