Nortel 1000E PRI Installation And Commissioning Manual page 70

70 Configure the Media Gateway Controller and DSP daughterboards in a PRI Gateway
For more information about configuring DTMF tone detection (DTR),
see Communication Server 1000E Installation and Commissioning
(NN43041-310).
Procedure 12
Configuring the Media Gateway Controller on a Call Server using LD 97
Step
1
2
3
Table 13
Media Gateway Controller configuration (LD 97)
Prompt Response
aaa
REQ
TYPE Supl
SUPL 0–252
SLOT <CR>
SUPT IPMG
The following prompts are for IPMG superloops only.
nn.nn.nn.nn
IPR0
IPMG_TYPE MGC
ZONE0
0-8000
DES0
... ...
DES1
... ...
Media Gateway 1000E PRI Gateway Installation and Commissioning
Action
Log on to the CS 1000E Call Server.
To access LD 97, enter:
LD 97
Enter the responses shown in
Controller configuration (LD 97)" (page
Description
Request (aaa = CHG, NEW)
Superloop
Superloop number. Add prefix X to delete.
Select default.
IP Media Gateway
Shelf 0 IPMG Uplink IP address. <CR> to skip to IPR1
when configuring new superloop; X to remove IPR0, DES0,
and ZONE0 data.
IPMG is controlled by MGC card.
Shelf 0 IPMG zone number. Zones used for IPMG
purposes must be configured as shared so that other IP
devices that are not in the same zone can gain access to
the IPMG devices.
No input, simply a header for the ELAN/TLAN designators.
This header and the ELAN/TLAN prompts only apply to
MGC-based IPMGs.
No input, simply a header for the ELAN/TLAN designators.
This header and the ELAN/TLAN prompts only apply to
MGC-based IPMGs.
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Table 13 "Media Gateway
70).
--End--