Removing The Air Conveyor; Removing The Front Fairing Lower Lockup - APRILIA SL Mille Workshop Manual

CHASSIS
.7.1.27 REMOVING THE AIR CONVEYOR
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
.INFORMATIONS).
• Turn the ignition switch to position
"§".
• Remove the front part of the fairing, see 7.1.19 (RE-
MOVING THE FRONT PART OF THE FAIRING).
• Only for the right air conveyor: disconnect the air
temperature sensor connector (1).
Upon reassembly, make sure that the electric con-
nector (1) is correctly coupled.
• Release the wiring from the special clamp (2).
Air conveyor rear screw driving torque: 2 Nm (0.2
kgm).
• Unscrew and remove the screw (3).
Air conveyor side screw driving torque: 3 Nm (O.3
kgm).
• Unscrew and remove the screw (4).
• Remove the air conveyor (5).
NOTE
If the conveyor gasket (6) is damaged, change
it.
To remove the air intake grid (7), proceed as follows:
• Unscrew and remove the screw (8).
• Release the coupling (9) from its seat.
• Remove the air intake grid (7).
NOTE
Where necessary, repeat the procedure to re-
move the other air conveyor cover.
7.1.28 REMOVING THE FRONT FAIRING LOWER
LOCKUP
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
• Position the vehicle on the stand.
Front fairing lower lockup screws driving torque: 7
Nm
(O.7
kgm).
• Unscrew and remove the three screws (10).
Take care not to damage the brake fluid pipes.
Nudge the front fairing lower lockup (11) along grad-
ually to determine the best position for sliding it out.
• Remove the front fairing lower lockup (11).
SL mille
11-
20 -
00
10
10
Release 00/2001-05