Removing The Front Part Of The Fairing - APRILIA RSV mile Use & Maintenance Book

REMOVING THE FRONT PART
OF THE FAIRING
Carefully read p. 84 (MAINTENANCE).
◆
Place the vehicle on the stand, see p. 83
(PLACING THE VEHICLE ON THE
STAND).
◆
Turn the ignition switch (1) to "
position.
◆
Unscrew and remove the two lower
screws (2).
★
◆
Unscrew and remove the side screw
(3).
The rear-view mirrors remain attached to
the front part of the fairing, but they will
not be not attached firmly. Do not use
the mirrors to handle the fairing, as you
will damage both mirrors and fairing.
★
◆
Unscrew and remove the two upper
screws (4).
★
NOTE
The position of the plate (5)
and how it fits with the seat (6) on the sup-
port frame on the front part of the fairing for
reassembly.
# Handle the plastic and painted compo-
" (OFF)
nents with care and avoid scraping or
damaging them.
Be very careful not to damage the elec-
trical cables.
◆
Move the front part of the fairing (7) sli-
ghtly forward.
◆
Lift the rubber boot (8).
◆
Disconnect the headlight electric con-
nector (9).
Upon reassembly, make sure that the
electric connector (9) is correctly cou-
pled.
◆
Remove the front part of the fairing (7)
completely, together with the headlight
and the rear-view mirrors.
Upon reassembly, tighten the screws
only moderately. Be careful not to over
tighten the screws, this will damage the
surrounding plastic and painted compo-
nents.
After reassembly:
◆
Correctly adjust the reflecting surface of
the rear view mirrors.
! -
use and maintenance RSV mille
!
117
RSV mille R