Table of Contents
Advertisement
D: ASSEMBLY
1. FRONT BUSHING
1) Set the ST A with the larger side of its inner di-
ameter turned upward.
2) Set the rear arm with the vehicle inner side of
arm turned downward.
3) Place the bushing on rear arm as shown in the
figure.
4) Place the ST B on bushing, and press-fit until
each edge surface of bushing and rear arm comes
to be aligned.
ST A 20099AE020 INSTALLER & REMOVER
SET
ST B 20099AE020 INSTALLER & REMOVER
SET
(2)
(1)
ST-B
ST-A
(1) 0±5°
(2) Rubber protrusion: Assemble with the rubber
protrusion side faced to the arm inner side
Rear Arm
2. REAR BUSHING
1) Press the bushing into the bore inside of ST D.
2) Set the ST C, ST D and bearing puller in the
specified position as shown in the figure, and then
press-fit the bushing until the outer end of bush and
rear end of rear arm in flat.
ST C 20099AE040 INSTALLER & REMOVER
ST D 20099AE040 INSTALLER & REMOVER
E: INSPECTION
Check the rear arm for bend, corrosion or damage.
RS-00221
RS-13
REAR SUSPENSION
SET
SET
ST-C
ST-D
RS-00056
Advertisement
Chapters
Table of Contents
