Subaru Legacy 2005 Service Manual page 2829

4) Install the pedal assembly, stopper, adjusting
rod, bushing and spring to clutch pedal bracket.
Tightening torque:
⋅
T: 30 N m (3.1 kgf-m, 22.4 ft-lb)
(A)
T
(B)
(A) Clutch pedal bracket
(B) Clutch pedal
5) Install the assist rod, bushing and assist spring
to clutch pedal and pedal bracket.
E: INSPECTION
1. CLUTCH PEDAL
Move the clutch pedal pads in the lateral direction
with a force of approx. 10 N (1 kgf, 2 lbf) to ensure
the pedal deflection is in specified range.
If excessive deflection is noted, replace the bush-
ing with new one.
Deflection of clutch pedal:
Service limit
5.0 mm (0.197 in) or less
• LHD model
(A)
(A) Clutch pedal
(B) Brake pedal
Clutch Pedal
CL-00276
(B)
CL-00098
CL-39
• RHD model
(A)
(A) Clutch pedal
(B) Brake pedal
F: ADJUSTMENT
1) Measure the amount of clutch pedal full stroke.
NOTE:
• Measure the length between the seat cushion
front end and center point of clutch pedal.
• Slide the seat at seventh notch from the first
notch.
Specified clutch pedal full stroke A:
Non-turbo model
130 — 135 mm (5.12 — 5.31 in)
Turbo model
135 — 140 mm (5.31 — 5.51 in)
A
(A)
(A) Clutch pedal (at full stroke condition)
(B) Scale
(C) Seat
2) If the full stroke is out of specification, loosen the
clutch stopper nut and adjust it.
Tightening torque:
⋅
8 N m (0.8 kgf-m, 5.8 ft-lb)
CLUTCH SYSTEM
(B)
CL-00077
(C)
(B)
CL-00078