Porsche 928 Workshop Manual page 1055

928 Automatic Transmission/Controls, Case
37
a
22. Lift transmission slightly and disconnect
holding chain.
23. Lower transmission only far enough that
central tube/transmission mounting bolts
and control cable mounting bolt can be
removed.
i$- -4
\
{- ~.' 0 '; CT:: 9"
1 .,. '\..
Y*.: +I '
1 it
' :.
lib
: t
2 ,+ -.
I
'a . z
,:i-
.-T, '
'.- '., ! ..,,
\
?
,;;a _ ~1 =-;. .,. '1
24. Move central tube to installed position,
mount rear brace with two bolts and place
a suitably thick block of wood between
central tube and brace.
25. Pull back transmission and lower carefully.
Installing
Note:
Installation is in reverse order of removal
procedures, but also conform with following
points.
I. Place central tube in installed position
with a suitably thick block of wood and
coat splines on central shaft with Optimoly
HT.
-jx=.
'~--z;
I!-.. ___ (,. <.I?
2. Lift transmission with universal trans-
mission jack and push on to central shaft.
a
Printed in Germany - VIII, 1984 Removing and Installing Transmission
37-121
n,
-.
,q P;
R
'I