Table of Contents
Advertisement
Before You Begin
1.5.3
Communication tools
Most of the procedures described in this manual require the use of a communication tool. Table 1-4
lists the transmitters discussed in this manual, and the communication tools that can be used with
them.
Table 1-4
Transmitters and communication tools
Model 1500
Model 1700 with analog outputs option board
Model 1700 with intrinsically safe outputs option board
Model 2500 with configurable input/outputs option board
Model 2700 with analog outputs option board
Model 2700 with intrinsically safe outputs option board
Model 2700 with configurable input/outputs option board
(1) Model 1700 and 2700 transmitters may be ordered with or without a display.
(2) Requires ProLink II v2.1 or later.
(3) Requires 375 Field Communicator.
(4) Partial support available with 275 HART Communicator; requires 375 Field Communicator for full support.
In this manual:
•
Basic information on using the display is provided in Chapter 2.
•
Basic information on ProLink II and connecting ProLink II to your transmitter is provided in
Chapter 3. For more information, refer to the ProLink II manual, available on the Micro
Motion web site (www.micromotion.com).
•
Basic information on the 275 HART Communicator, the 375 Field Communicator, and
connecting the Communicator to your transmitter is provided in Chapter 4. For more
information, refer to the HART Communicator or Field Communicator documentation
available on the Micro Motion web site (www.micromotion.com).
You may be able to use other tools from Emerson Process Management, such as AMS. Use of AMS is
not discussed in this manual; however, the user interface that AMS provides is similar to the
ProLink II user interface.
1.6
Planning the configuration
The pre-configuration worksheet in Section 1.7 provides a place to record information about your
flowmeter (transmitter and sensor) and your application. This information will affect your
configuration options as you work through this manual. Fill out the pre-configuration worksheet and
refer to it during configuration. You may need to consult with transmitter installation or application
process personnel to obtain the required information.
If you are configuring multiple transmitters, make copies of this worksheet and fill one out for each
individual transmitter.
Configuration and Use Manual
ProLink II
(1)
display
software
✓
(2)
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
Communicator
✓
(3)
✓
✓
✓
(4)
✓
✓
✓
5
Advertisement
Table of Contents
