Communication Tools And Protocols - Emerson Micro Motion 4200 Configuration And Use Manual

Configuration and Use Manual
MMI-20048166
Figure 1-3: 4200 transmitter -- Remote mount
A. Transmitter housing cover
B. Clamping ring
C. Junction box
The transmitter is installed remotely from the sensor. The 9-wire connection between the sensor and
transmitter must be field wired. Power supply and I/O must be field wired to the transmitter. The sensor
connection is in the junction box.

1.4 Communication tools and protocols

You can use several different communications tools and protocols to interface with the transmitter, use
different tools in different locations, or use different tools for different tasks.
Tool
Display
ProLink III
Field Communicator
For information about how to use the communication tools, see
Using a Field Communicator with the transmitter
Configuration and Use Manual
Supported protocols
Not applicable
• HART
• "Factory Use Only" port in non-hazardous areas
• HART
Using ProLink III with the transmitter
in this manual.
Before you begin
April 2019
and
9