Emerson Micro Motion 1000 Series Configuration And Use Manual page 29

Connecting with ProLink II or Pocket ProLink Software
Figure 3-2 RS-485 terminal connections to Model 1700 or 2700 AN
PC
25-pin to 9-pin serial port
adapter (if necessary)
RS-485 to RS-232
signal converter
Figure 3-3 RS-485 network connections to Model 1700 or 2700 AN
PC
25-pin to 9-pin serial port
adapter (if necessary)
5. Start ProLink II. Choose
6. Set
Protocol
transmitter. See Section 8.15.
Note: If you do not know the transmitter's RS-485 configuration, you can connect through the service
port, which always uses default settings, or you can use the Communicator or the display to view or
change the transmitter's RS-485 configuration.
7. Set the
Address/Tag
transmitter. The default Modbus address is 1; the default HART polling address is 0. See
Section 8.15.
8. Set the COM Port
9. Click
Connect
Configuration and Use Manual
DCS or PLC
RS-485 to RS-232 Add resistance if necessary
signal converter (see Step 4)
Connection > Connect to Device
, , , and
Baud Rate Stop Bits
value to the Modbus or HART polling address configured for the
value to the PC COM port assigned to this connection.
.
Model 1700 or 2700 transmitter
terminal compartment
(transmitters with analog outputs
option boards only)
.
to the RS-485 values configured in the
Parity
19