Delivery Condition Of The Actuators; Information Notice (Tag) - Emerson Bettis RTS FQ Series Operating Manual

Section 3: General
February 2019
3.8

Delivery Condition of the Actuators

For each actuator, an inspection report is generated upon final inspection. In particular, this
comprises a full visual inspection, calibration of the torque measurement in connection
with an extensive run examination and a functional test of the microcontrollers.
These inspections are conducted and documented according to the quality system and can
be made available if necessary.
The basic setting of the end position must be performed after assembly on the actuator.
CAUTION
Commissioning instructions (see Section 5, page 25) must be strictly observed!
During assembly of the supplied valves at the factory, end postions are set and
documented by attaching a label (see Bild 16). During commissioning at the plant,
these settings must be verified.
3.9

Information Notice (Tag)

Each actuator is provided with a bilingual tag containing key information, which is attached
to the handwheel after final inspection. This tag also shows the internal commission
registration number (see Figure 5).
Figure 5
7
Tag
User Instructions
MAN-02-04-60-0351-EN Rev. 3
General