Emerson Bettis RTS FQ Series Operating Manual page 35

User Instructions
MAN-02-04-60-0351-EN Rev. 3
Figure 38
Figure 39
7.3.1
Use the selector switch (red) to determine the various operating states of the actuator. In
each of these positions, it is possible to block the switch by means of a padlock and thus
protect the actuator against unauthorized access.
The selector switch has the following positions:
Table 3.
Besides defining the operational status, the selector switch is used in configuration mode
to confirm or cancel parameter inputs.
Depending on the selector switch position, the control switch performs different functions:
Control Unit
Halfway Switch Flip (it will jump to the next parameter category)
Full Switch Flip (it will jump to the end of the menu)
Operation Mode
Operating Mode Table
OFF
It is possible to operate the actuator by motor via the control
switch. Control via the remote inputs may be possible with
Local
appropriate configuration (superimposed control commands,
The actuator is ready to process control commands via input
Remote signals. The control switch for the motor operation of the
The actuator can be neither operated via the remote
control nor via the control switches of the controller.
emergency commands).
actuator is not enabled.
Section 7: Control Unit
Febraury 2019
30