Emerson Bettis RTS FQ Series Operating Manual page 36

Section 7: Control Unit
February 2019
Table 4.
Selector switch in the
Selector switch in the
REMOTE position
Selector switch in the
LOCAL position :
7.3.2
In principle, all parameters are shown as numbers in the corresponding parameter point.
From the actuator menu, use the control switch to access different menu points. The lower
left corner of the display shows the "EDIT?" option.
Figure 40
Confirm the selector switch with a slight flip towards
change the selected parameter. To confirm this input readiness, the display changes from
"EDIT?" to "SAVE?".
Figure 41
31
Selector Switch Position Table
according to internal symbolism. From the neutral position
OFF position: Towards the symbols you reach the parameter menu. Here, the
The control switch gives you access to status, history data and
:
With the control switch, the actuator can be operated by motor.
You may also operate the actuator in inching and self-hold mode.
Switches are spring-loaded to snap back automatically into their
neutral position. (To confirm a control command, the control switch
must be pushed all the way into its mechanical locking position.)
Configuration
Display (11)
Display (12)
The control switch is used to scroll up or down the menu
towards you reach the status and history data areas.
selection switch either confirms or rejects the
current input according to associated symbolism.
parameter area.
User Instructions
MAN-02-04-60-0351-EN Rev. 3
, (see Figure 24 to Figure 28) to
Control Unit