Parameter Group: Control; Parameter Group: Password - Emerson Bettis RTS FQ Series Operating Manual

Section 8: Parameter Menu
February 2019
8.5

Parameter Group: Control

Table 9.
P6.2
P6.5
3)
P6.6
since firmware 1.303
3)
8.6

Parameter Group: Password

The actuator control can be password-protected to prevent access at different levels. It is
possible to prevent entry by unauthorized personnel or to entirely lock motor operation.
Default password is set to "000änd thus deactivated. You can use both numbers and capital
letters in your password. After entering a password, password protection is activated.
To remove password protection, enter an empty password (000).
When accessing a password-protected parameter, the user is automatically prompted for
its introduction. Only after correctly entering the password, it is possible to change the
corresponding parameters.
Table 10.
P7.1
P7.2
P7.3
41
Control Parameter Group
Sub Menu
Menu Item
Item
Control Ready delay
Control 24V output
Control Min. impuls
Password Parameter Group
Sub Menu
Menu Item
Item
Password Reading PWD
Password Writing PWD
Bluetooth
Password
PWD
Poss.
Notes / Comments
Setting
0 - 10 sec. Drop-out delay for the ready signal (Binary outputs)
24V auxiliary output is deactivated (chapter 22.5).
0 The function of the auxiliary input is still activated.
{1} 24V auxiliary output is activated (chapter 22.5).
0.1 - 2.0
Minimum switch-on time of the motor.
sec
Poss.
Notes / Comments
Setting
Status display and history data are still viewable; access
to the parameter menu is locked until this password is
3-digit introduced. Parameter menu scrolling is only enabled
after entering the password. Electric motor operation is
unlocked.
Status display, history data and parameter menu can be
3-digit
viewed. However, parameters become read-only.
Password for the Bluetooth connection, empty
15-digit
password deactivates the password request.
User Instructions
MAN-02-04-60-0351-EN Rev. 3
Parameter Menu