Parameter Group: Characteristic Curves (Optional) - Emerson Bettis RTS FQ Series Operating Manual

Section 8: Parameter Menu
February 2019
8.15

Parameter Group: Characteristic Curves (optional)

With this option, customers can enable travel-dependent torque characteristic curves.
With these characteristic curves, torque limits already set under menu item P2 (torque) can
be further reduced depending on travel. Characteristics can be configured via the infrared
interface with the SMARTTOOL software (see Figure 57).
Figure 57
Table 25.
P17.1
P17.2
57
Characteristic Curves Display
Characteristic Curves Parameter Group
Sub Menu
Menu Item
Item
Characteristic Torque Open
Torque
Characteristic
Closed
Poss.
Notes / Comments
Setting
The torque characteristic curve is disabled for the
0: Off
OPEN direction.
The torque characteristic curve is enabled for the
1: On
OPEN direction.
The torque characteristic curve is enabled for the
2: Local +
OPEN direction only in LOCAL and REMOTE
Remote only
mode (while disabled in the EMERGENCY mode).
The torque characteristic curve is disabled for the
0: Off
CLOSED direction.
The torque characteristic curve is enabled for the
1: On
CLOSED direction.
The torque characteristic curve is enabled for the
2: Local +
CLOSED direction only in LOCAL and REMOTE
Remote only
mode (while disabled in the EMERGENCY mode).
User Instructions
MAN-02-04-60-0351-EN Rev. 3
Parameter Menu