Emerson Bettis RTS FQ Series Operating Manual page 43

User Instructions
MAN-02-04-60-0351-EN Rev. 3
P1.4
P1.5
P1.6
P1.7
P1.8
P1.9
P1.10 End limit
P1.11 End limit
P1.12 End limit
representative for CM03
1)
Parameter Menu
by travel (1)
by torque (1)
Switch off
End limit Close
by torque1 (2)
by torque2 (3)
by travel1 (4)
right (0)
Closing
End limit
direction
left (1)
0
Rot. sense
End limit
pos.
1
Close=green (0) Definition of the LED colour of the CLOSED or OPEN
LED
End limit
function
Close=red (1)
End limit
End limit 0,1 - 10,0%
hyst
End limit Ramp 0.1 - 100%
Range 0 - 100%
Overrun
0 - 60 s
Open
Overrun
0 - 60 s
Close
Section 8: Parameter Menu
The actuator uses end-position signals to switch off
and report the end position.
The actuator signals the end position or stops the motor only after
reaching the specified torque with the proviso that it has reached
the end position. If the end position signal is not reached,
the actuator reports an error.
see P1.3
see P1.3
see P1.3
Actuator is designed for clockwise = closing.
Reverse direction of rotation! Counterclockwise = closing.
The crossing of all signals and commands is performed
by the controller.
Rotation sense of the Potentiometer. No function in
Bettis RTS CM series.
end postion signalization.
Hysteresis range for end position signals: Example: End position
hysteresis 1% means, that the End position OFF is reached when
closing 0%, and will leave it when opening only at 1%, i.e.,
a re-closing can only take place after leaving this hysteresis.
When approaching the end position, the speed is reduced.
End position range for torque (P1.3, P1.4).
Permissible range in which the torque is to be
achieved. If the actuator comes to the end of the
end position range, the motor shuts off even if the
torque has not been reached.
Switch-off delay after reaching the end position see
travel1 (P1.3, P1.4)
Switch-off delay after reaching the end position
travel1 (P1.3, P1.4)
Febraury 2019
38