Emerson Bettis RTS FQ Series Operating Manual page 66

Section 9: Status Area
February 2019
Display Overview:
1.
2.
9.1.3
Figure 60
Display Overview:
1.
2.
3.
4.
9.1.4
Figure 61
Display Overview:
1.
2.
3.
4.
61
Input Number
Signal (0 = Low; 1 = High)
Status – Analogue values
Display of analogue values: Input 1 (In1) is used by the positioner as the setpoint;
Input 2 (In2) serves as an external value for the optional PID controler. In the
analogue output (out), only the control signal is shown, regardless of whether the
output current actually flows or not (interruption of the current loop).
Analogue Status Display
Input 1
Input 2
Output
All values in mA
Status – Absolute values
This status displays the absolute position of the actuator.
Absolute Value Display
Absolute value of the position unit
Relative value of the position unit
Absolute value of the torque unit
Relative value of the position unit (calibrated in factory)
User Instructions
MAN-02-04-60-0351-EN Rev. 3
Status Area