Parameter Group: Binary Outputs - Emerson Bettis RTS FQ Series Operating Manual

Section 8: Parameter Menu
February 2019
8.9

Parameter Group: Binary Outputs

The controller is equipped with 8 freely configurable binary outputs. Please find further
information on technical data of the binary outputs in Section 17.1. Provided with external
supply, binary outputs are optically isolated from the rest of the controller.
Default binary outputs are as follows:
•
•
•
•
•
•
•
•
Table 14.
P10.1
45
Output 1: Ready
Output 2: End position OPEN
Output 3: End position CLOSED
Output 4: Run OPEN
Output 5: Run CLOSED
Output 6: Torque
Output 7: LOCAL
Output 8: REMOTE
Binary Outputs Parameter Group (1)
Menu Sub Menu
Poss. Setting
Item Item
0: User defined
1: Ready
2: Fault
3: Open
4: Closed
5: Running Open Actuators runs in direction Open
6: Running
Closed
7: Runing
8: Torque Open
9: Torque Closed
Binary
Output 1
Output
10: Torque
11: Travel Open
12: Travel Closed The Closed end postiion has been reached
13: Pos. > Int.1
14: Pos. < Int.1
15: Pos. > Int.2
16: Pos. < Int.2
17: Pos. > Int.3
18: Pos. < Int.3
19: Pos. > Int.4
20: Pos. < Int.4
21: Local
MAN-02-04-60-0351-EN Rev. 3
Notes / Comments
Optional
Actuator is ready
General fault; actuator is not ready
Actuator is in open position
Actuator is in closed position
Actuators runs in direction Closed
Actuator is running in either Open or Closed
Switch off torque was reached in Open direction-
actuator has been switched off
Switch off torque was reached in Closed direction-
actuator has been switched off
Switch off torque was reached in either Closed or
Open direction
The Open end postion has been reached
Position > Intermediate position 1
Position < Intermediate position 1
Position > Intermediate position 2
Position < Intermediate position 2
Position > Intermediate position 3
Position < Intermediate position 3
Position > Intermediate position 4
Position < Intermediate position 4
Local operating mode (selector switch in position)
User Instructions
Parameter Menu