C163: Master Data Area Base Address; C164: Serial Time Out; C165: Serial Response Delay; C170: Load Type - Santerno DCREG2 Series User Manual

DCREG2
DCREG4
7.3.51 C163: M
C163 BaseAddress
# *****
7.3.52 C164: S
C164 RTUTimeOut
**** ms
7.3.53 C165: S
C165 RxTxDelay
**** ms
7.3.54 C170: L
C170 LoadType
***
D A
ASTER ATA
P C163 - BaseAddress
# 0 ... 32767
R
# 0
D
This parameter indicates the correspondence between the drive data area and
F
the master data area.
T O
ERIAL IME UT
C164 – RTUTimeOut
P
0.00 ... 2000 ms
R
300. ms
D
This parameter indicates, in milliseconds, the timeout of the drive (time out)
F
while receiving an additional character, before considering the inquiry
transmitted by the master a concluded message.
R
ERIAL ESPONSE
P C165 - RxTxDelay
0.00 ... 2000 ms
R
0.00 ms
D
This parameter concerns the half duplex transmission mode only, like the two-
F
wire RS485 standard. It defines, in milliseconds, the delay time of the drive
before its response to a master inquiry, to make sure that the latter has already
switched to the listening mode.
T
OAD YPE
C170 - LoadType
P
0 ... 1
R
0
D
F This parameter indicates the load type connected to the output terminals.
0:Motor. Output terminals connected to the armature of a DC motor.
1:Inductance. Output terminals connected to an electromagnet.
B A
REA ASE DDRESS
D
ELAY
15P0059B3
USER MANUAL
183/200