M012: Auxiliary Analog Input 3 On Terminal; M013: Up/Down Internal Reference; M014: Main Analog Input To Terminals 5 And 7; M015: Serial Connection Reference - Santerno DCREG2 Series User Manual

15P0059B3
USER MANUAL
7.1.13 M012: A
M012 AnalogIn3
AnIn3 ***** %
7.1.14 M013: U
M013 UpDownref
UpDnRef ***** %
7.1.15 M014: M
M014 TermRef
TermRef ***** %
7.1.16 M015: S
M015 SLinkRef
SLRef ***** %
126/200
A
UXILIARY NALOG
P M012 - AnIn3
-100. ... 100. %
R
This parameter indicates, as a percentage of the max. reference corresponding
F
to 10V, the value of the reference resulting from IN 3 reference application
between terminal 19 and 0V. The reference obtained may be configured through
parameter C122.
The value per cent displayed in this parameter takes account of the Gain, Bias
and Polarity blocks (see parameters P134, P133 and P132 respectively) and of
the Reverse function - only if an input is configured as a speed additional
reference - applied in the above-mentioned order.
/D I
P OW N NTERNAL
P M013 - UpDnRef
R -100 ... 100. %
F This parameter indicates, as a percentage of the max. reference corresponding
to 10V, the value of the reference assigned to the Up/Down internal variable.
A I
AIN NALOG
P M014 - TermRef
R -100 ... 100. %
F This parameter indicates, as a percentage of the max. reference corresponding
to 10V, the value of the reference resulting from the application of the REF main
analog input between terminals 5 and 7. The reference obtained is either a
speed / voltage reference or a current reference if the 6:Slave function is
entered through a digital input (see par. C130 ... C135).
The value per cent displayed in this parameter, either as a speed / voltage
reference or a current reference, considers the Gain, Bias and Polarity blocks
(see par. P122, P121 and P120, or par. P125, P124 and P123 respectively for
the two types of references) applied in the above-mentioned order.
For example, if a motor rotates at 2000 RPM with a 10V reference and if P122 =
100%, then with a 10V reference and if P122 = 25% the motor will rotate at 500
RPM (the display will show M014 = 25% and M001 = 25%); otherwise, with a
2.5V reference and if P122 = 200%, the motor will rotate at 1000 RPM (the
display will show M014 = 50% and M001 = 50%).
The value per cent displayed in this parameter also indicates the reference
obtained from a current external signal (milliAmpere) if jumper JP407 in the
control board is set in pos. 2-3: if the user intends to use an analog input as a
0(4) ... 20mA signal, the value to program in the parameters relating to the
Gain and Bias operators is stated in the INPUT / OUTPUT SIGNAL IN
MILLIAMPERE chapter.
C
ERIAL ONNECTION
P M015 - SLRef
-100. ... 100. %
R
This parameter indicates, as a percentage of the max. value corresponding to
F
10V, the value of the reference applied through serial connection.
I 3
NPUT ON
R
EFERENCE
T
NPUT TO ERMINALS
R
EFERENCE
DCREG2
DCREG4
T
ERMINAL
5 7
AND