Dcreg2 Setting Parameter Values Different From Default Values - Santerno DCREG2 Series User Manual

15P0059B3
USER MANUAL
6.10.6 DCREG2 S
D
EFAULT
P003 = 1
P011 = 1.15 x V
MAINSnom
P031 = 10 s
P034 = 60 s (example)
P059 = 0.01 %/s
P070 = 1
P071 = 0.1 s
P100 = 1.5
P101 = 10 ms
P102 = 100 ms
V

nom
P122 = 100
P 011
voltage
P176 = 5
P177 = 3 s (example)
P181 = 1
P185 = 5%
P211 = +100%
P230 = 30°
I
EM nom 
C000 = 100
I
DRIVE nom
C030 = V
MAINSnom
C070 = 4
C150 = 1
C151 = 1
C153 = 1
C154 = 1
C156 = 1
C157 = 1
C170 = 1
NOTES
1. Set P000 = 1 to alter the parameters above.
2. Save all changes made to the parameters above. The remaining parameters are expected to be
left at their default values (factory setting).
3. If an oscilloscope is used to monitor the response to a current reference step, temporarily change
the value of parameter C133 from 1: Preset Speed A (default value) to 6: Slave Enabled. If so, the
reference set on potentiometer PV (that must not be set at its max. value to avoid current limit) becomes a
current reference, for the time set in P177. The current waveform may be read on terminal 8 by setting
par. P150 to 9: ArmatureCurr
118/200
P
ETTING ARAMETER
V
ALUES
Advanced programming level
Boost DC voltage forcing energizing current
Down ramp time of positive voltage reference
Down ramp during partial demagnetisation
Ramp over current reference
Proportional gain kp of voltage regulator
Integral time Ti of voltage regulator
Proportional gain kp of current regulator
Integral time Ti of current regulator (discontinuous operation)
Integral time Ti of current regulator (continuous operation)
Gain over REF for magnet rated voltage as a percentage of boost
Digital output MDO 2 set as Drive Running
Digital output MDO 2 enabling delay for starting boost duration setting
Digital output MDO 2 set up with normally closed logic
Current threshold for digital output MDO 3 as a perc. of I
PresetSpd 1 for boost upon energizing
Minimum delay angle
Magnet rated current expressed as a percentage of the converter size
Three-phase, rated supply voltage for the converter
Armature feedback
Alarm A001 trip disabled (Field current failure)
Alarm A004 cleared (Load loss)
Alarm A006 trip disabled (Unstable mains frequency)
Alarm A007 trip disabled (No supply phase)
Alarm A010 trip disabled (Output over voltage)
Alarms A016/17 trip disabled (Tolerance exceeded by mains voltage )
Selection of inductive load
V D
ALUES IFFERENT
DCREG2
DCREG4
F
ROM
DRIVEnom