C017: Boost Over The Field Current; C018: Boost Duration On Field Current; C030: Nominal Mains Voltage - Santerno DCREG2 Series User Manual

15P0059B3
USER MANUAL
7.3.10 C017: B
C017 FldFrcLevel
*** %
This forcing function (Field Forcing) will be disabled if the armature voltage exceeds the following value
030 
C . 1 316
, and will be enabled when drive is started again. See also the FIELD REGULATOR chapter.
2
NOTE
NOTE
7.3.11 C018: B
C018 FldFrcTime
*** sec
7.3.12 C030: N
C030 VmainsNom
*** V
NOTE
166/200
OOST OVER THE
P C017 - FldFrcLevel
100 ... 120 %
R
100 %
D
This parameter may be programmed even when no dynamic regulation of the
F
field current in field weakening mode is needed. It represents the value,
expressed as a percentage of C010 (IfldNom), to which the field current is
increased according to the time set at parameter C018 (FldFrcTime), starting
from the very moment when the run command is operated. This is true only
when a digital input configured for the 11:FldFrcEnabled function is closed.
Product C010•C017 should not exceed the 100% of the field maximum current
to be supplied by the device.
The forcing function may have no effect if the current increase does not produce
any remarkable field flux increase.
D
OOST URATION ON
P C018 - FldFrcTime
0.0 ... 60. s
R
10. s
D
This parameter may be programmed even when no dynamic regulation of the
F
field current in field weakening mode is needed. This is the time interval,
expressed in seconds, during which the field current is increased according to
the percentage set at parameter C017 (FldFrcLevel) starting from the very
moment when the run command is operated. See also the FIELD REGULATOR
chapter.
M
OMINAL AINS
C030 – VmainsNom
P
10 ... NNN V
R
400 V
D
This parameter sets, in Volts, the three-phase mains voltage nominal value in
F
the power section.
The upper extreme value to be set (i.e. the maximum three-phase voltage to be
supplied to the power section) indicated as NNN, is factory-set, is shown in the
Status page and depends on the components used for the device
manufacturing. It may be one of the following four values: 440V, 500V, 600V,
690V.
The value set in this parameter controls alarm A016 (Mains OverVoltage), A017
(Mains UnderVoltage) and A010 (Armature OverVoltage) trip (mains overvoltage
or undervoltage and armature overvoltage respectively).
The value set in this parameter cannot exceed the drive factory-set value.
F C
IELD URRENT
F C
IELD URRENT
V
OLTAGE
DCREG2
DCREG4