C159: Alarm A028 Trip Disabling; C160: Serial Connection Drive Address; C161: Serial Connection Transmission Speed; C162: Serial Connection Parity Control - Santerno DCREG2 Series User Manual

15P0059B3
USER MANUAL
7.3.47 C159: A
C159 A028 (FBus)
***
7.3.48 C160: S
C160 DeviceID
# ***
7.3.49 C161: S
C161 BaudRate
*** bps
7.3.50 C162: S
C162 Parity
***
182/200
A028 T
LARM RIP
P C159 - A028(FBus)
0 ... 1
R
1
D
It disables alarm A028 (FieldBus Failure) trip.
F
0:Included. The alarm is enabled.
1:Excluded. The alarm is disabled.
C
ERIAL ONNECTION
P C160 - DeviceID
#1 ... 247
R
#1
D
This parameter indicates the physical address identifying the DCREG drive in
F
theMODBUS connection relating to the serial network which it is connected to (if
any).
C
ERIAL ONNECTION
P C161 - BaudRate
R 1200 ... 128000 bps
D 9600 bps
F This parameter expresses the serial connection transmission speed (baud rate)
in bits per second.
1200. The transmission speed is equal to 1200 bps.
...
128000. The transmission speed is equal to 128000 bps.
C
ERIAL ONNECTION
P C162 - Parity
0 ... 2
R
0
D
This parameter indicates whether the parity control is enabled and specifies the
F
type of control.
0:None. No parity control is to be found. Each character ends with two STOP
BITS.
1:Even. The parity control is enabled. It is an "even" parity control (the data to
be transmitted are added a bit, so the total number of "1" is even). Each
character ends with a STOP BIT only.
2:Odd. The parity control is enabled. It is an "odd" parity control (the data to be
transmitted are added a bit, so the total number of "1" is odd). Each character
ends with a STOP BIT only.
D
ISABLING
D A
RIVE DDRESS
T
RANSMISSION
P C
ARITY ONTROL
DCREG2
DCREG4
S
PEED