Ctm - Cti Module (Tapi) (Figure 6-4); Connecting A Ctm (Tapi) - Samsung DCS 816 Installation Manual

SAMSUNG
DCS-816

6.5 CTM - CTI Module (TAPI) (Figure 6-4)

The DCS Computer Telephony Module (CTM) is required to support CTI (TAPI) in the system.
The CTM has a DLI connection and a personal computer (PC) interface, which can be connected
to any DLI port of DCS-816. The system requires MDF connection for the CTM and modular jack
connection for a keyset. A PC may connect to the module via the DB9 connector. See Figure 2-3
and refer to section 2.5 (MDF Cabling).
Using one pair twisted wires, connect each CTM (via the modular jack marked 'DLI IN') to the DLI
port of your choice via the Champ connector on the base board and then connect the CTM (via the
other modular jack marked 'KTS OUT') to a keyset. A PC can be connected to the CTM via the
DB9 connector.
A special PC software package is required to run CTI (TAPI) and how to set up the software is de-
scribed in the other document in detail. Contact your dealer for information.
25 PAIR CABLE WITH FEMALE CONNECTOR TO THE BASE CHAMP CONNECTOR
KTS· OUT
RS-232-C(DB-9)

CONNECTING A CTM (TAPI)

CHAMP CONNECTION
PIN COLOUR
39/14 BK-BR/ BR/BK T/R, 1
40/15 BK-S/ S-BK
41/16 Y-BL/ BL-Y
42/17 Y-O/ O-Y
43/18 Y-GR/ GR-Y
44/19 Y-BR/ BR-Y
45/20 Y-S/ S-Y
46/21 VL-BL/BL-VL
47/22 VL-O/ O-VL
48/23 VL-GR/ GR-VL T/R, 10
49/24 VL-BR/ BR-VL T/R, 11
50/25 VL-S/ S-VL
C TＭ
T X D 2
R X D 3
G N D 5
DLI· IN
CONNECT A CTM TO ANY DLI PORT
YOU CANNOT INSTALL THE EQUIPMENT OUTDOORS
SPECIAL PC SOFTWARE REQUIRED
CIRCUITS / FUNCTIONS
T/R, 2
T/R, 3
T/R, 4
T/R, 5
T/R, 6
T/R, 7
T/R, 8
T/R, 9
T/R, 12
P I N A S S I G N M E N T
Ｐ Ｃ
C O M 1 C O M 2
2 3 ( R x D )
3 O R 2 ( T x D )
5 7 ( G N D )
9 P I N 2 5 P I N
6-5
Installation Manual
st
DLI port on base
nd
DLI port on base
rd
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
th
DLI port on base
FIGURE 6-4