Engine Oil Relief Valve - Remove And Install (Engine Oil Pump) - Perkins 1103 Disassembly And Assembly

50
Disassembly and Assembly Section
Installation Procedure for the Four
Cylinder Engine
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 94
1. Clean the mating surfaces of the housing (3) and
the cylinder block.
2. Position the engine oil cooler (2) and the new
seals (5) in the housing (3). Install the setscrews
(7) in order to secure the engine oil cooler (2) to
the housing (3).
Note: Do not use sealant on the joint (1).
3. Position the housing (3) and the new joint (1) onto
the cylinder block. Install the setscrews (4) and
the setscrews (6) in order to secure the housing
(3) to the cylinder block.
4. Tighten all of the setscrews (4, 6 and 7) to the
correct torque. Refer to the Torque specifications
Manual, "Standard Torques for Metric Fasteners"
for further information.
Note: Refer to the Operation and Maintenance
Manual, "Refill Capacities" for the cooling system
capacity and for the lubrication system capacity of
the engine.
5. Fill the cooling system with coolant. Fill the
lubrication system with engine oil.
Engine Oil Relief Valve -
Remove and Install
(Engine Oil Pump)
Removal Procedure
Start By:
a. Remove the engine oil pan. Refer to this
Disassembly and Assembly Manual, "Engine Oil
Pan - Remove and Install".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g00952614
Illustration 95
Personal injury can result from being struck by
parts propelled by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use all
recommended tooling to release the spring force.
1. Remove the plug (2). Remove the spring (3) and
the plunger (4) from the engine oil pump (1).
SENR9779-02
i01958106
NOTICE
g00959674