Insert License Key - Siemens FS20 Mounting & Installation

5.30 Insert license key

Building Technologies
Fire Safety
The license key is inserted in the designated holder on the rear of the operating
unit.
Figure 116: Using the license key on the operating unit with PMI & mainboard FCM2027
Figure 117: Using the license key on the operating unit with PMI & mainboard FCM2004
1 Holder for the license key
2 License keys
Disconnect the station from the power supply
If the station is not disconnected from the power supply or if the license key is
inserted when the station is switched on, the license key functions will not be
enabled.
You will find a detailed description of how to disconnect the station from the
power supply in document 009052.
License key installation position: The wider side points toward the clamp, the
narrower side toward the printed circuit board.
w The station is current-free, i.e., it has been disconnected from the power supply
and the batteries have been disconnected too.
Raise the clamp of the retainer (1) and push the license key (2) underneath the
l
clamp.
a After a restart, the new functions will be enabled.
Mounting and installation of the compact control panels
5
Insert license key
2
1
1
2
217 | 354
008851_s_en_--
2016-01-27