Siemens FS20 Mounting & Installation page 29

Building Technologies
Fire Safety
9 Recesses for the hinges of the operating add-on
10 Mounting holes for the operating add-on
11 Power supply (150 W)
12 DIN rail for additional components
13 Holes for wall mounting (bottom)
14 Primary-side cabling of the power supply
15 DIN rail with network separation terminals and for additional components
16 Strain relief for mains supply cable
17 Card cage (5 slots) for module bus cards.
18 Mounting plate with slots for fastening the shield connection terminal blocks
The mounting plate, as a carrier for the periphery board and the card cage, is
1
offset around 2 cm from the rear panel. The cables of the external supplies and
power line can then be led behind the mounting plate.
Setup of the compact control panels
Station rear panels (packaging unit)
3
1
29 | 354
008851_s_en_--
2016-01-27