Siemens FS20 Mounting & Installation page 160

Mounting and installation of the compact control panels
5
Card cage
160 | 354
Building Technologies
Fire Safety
Installation of card cage (5 slots) FCA2008-A1 in FC2060
6 5
Figure 85: Installation of card cage (5 slots)
1 Rear panel (FC2030) or mounting plate (FC2060)
2 Periphery board
3 Card cage housing cover (EMC protection)
4 Card cage
5 Mounting holes for screws (2) in card cage housing
6 Mounting holes for screws (4 pieces) in printed circuit board
1. Tighten the 4 fixing screws of the printed circuit board (6) as follows:
– For the FC2030 on the rear panel (1, top figure)
– For the FC2060 on the mounting plate (1, bottom figure)
2. Tighten the 2 fixing screws in the card cage housing (5) as follows:
– For the FC2030 on the rear panel (1, top figure)
– For the FC2060 on the mounting plate (1, bottom figure)
3. Insert the desired module bus cards in the card cage (see chapter 'Module bus
cards [➙ 166]').
4. Mount the housing cover (3) of card cage and secure with the four screws.
5. Connect the card cage according to the following pin assignment.
4
1
2
3
008851_s_en_--
2016-01-27