Table of Contents
Advertisement
Instructions for use
4.1.3 Filling and heating
You can see what the machine is doing on the machine's panel.
•
•
•
•
•
•
•
•
NB: The time needed to heat the water to the right wash temperature depends on
the temperature of the incoming water.
4.1.4 Filing and heating the machine using TimerStart (optional)
Using the TimerStart function, the dishwasher can start filling and heating water
in the washing tank automatically at a set time. The dishwasher is then ready for
washing when the next wash cycle starts and you don't have to wait for the machi-
ne to fill the tanks and heat the tank water before washing can start, which takes
approx. 30 minutes.
For machines equipped with the TimerStart function, the machine must be in
stand-by mode in order to start automatically, i.e. the TO/FROM BUTTON (10) is
pressed and the following message is shown on the machine's display (1):
TIMERSTART
ACTIVATED
Timer
WD-215T
Turn the main switch (14) to the ON position.
Close the doors
Press button (10) to switch on the power supply.
Press button (3). The machine will start to fill with water.
When the tank is full heating of the water begins.
Once the heating is finished, the machine will start and run for a short pe-
riod to mix the detergent.
When the detergent is mixed, the message on the display indicates that the
feed should start. Activate the feed by pressing the button (5).
The machine is now ready to wash.
SE T
A
B
90-9-05-002-a
A=Buttons for setting and checking
B=Switch
C=Display
23
C
Rev. 6.0 (201812)
Advertisement
Table of Contents
