Filling And Heating The Machine - Wexiodisk WD-6 DUPLUS Installation And User Manual

Operating instructions

4.1.3 Filling and heating the machine

•
•
•
•
•
•
WD-6 DUPLUS
Switch on the power using the 0/1 button (9) on the panel.
Close the hood. On machines with automatic hood lift, the hood is closed
by pressing button (5). The filling and heating process will begin.
The display (1) shows two dashes "--" until the machine has been filled.
The display (4) shows "P0". P0 is a pause mode which indicates that no
washing programme has been selected. The symbol (2) is lit.
C
6D_P0
Once the dishwasher is full, the symbol (3) lights up and the display (1)
shows the temperature of the washing water. If the washing temperature
falls below the set value by more than 5° C, the temperature display flashes.
The temperature on the display will also flash if the washing temperature is
below 50°C.
C
6D_temp
The water in the washing tank will continue to be heated until the correct
washing temperature has been reached. The heating time is dependent on
incoming water temperature, the power output of the booster heaters and
any extra equipment. The normal operating temperature for the washing
phase is 60° C. The machine can be set up so washing cannot start until the
correct washing temperature has been reached.
Once the correct temperature has been reached, the washing pump will
start and run for a short period to mix the detergent.
33
Rev. 4.0 (202202)