Table of Contents
Advertisement
Installation instructions
3.6 Trial operation
3.6.1 Start-up schedule
Prepare the machine for trial operation by following the INSTRUCTIONS FOR
USE. The instructions describe the measures that must be taken to prepare the
machine for operation.
This should be completed and signed by the customer on start-up.
Machine type:
Machine serial number:
Installation date:
Read the installation and user manuals carefully. Then check the following points:
1. Check:
•
Water, steam and drain connections
•
That the machine is evenly balanced
•
That the closed doors are in line
•
The adaptation of any tray dispensers
•
Detergent and drying agent
•
That the filters, level pipe and curtains are in position
•
The mini-switches for all the heating elements must be in the OFF position.
•
That the overheating protection device is reset
2. Filling the machine:
•
Switch on the main switch and press the 0/1 button
•
Close the doors
•
Fill the machine with water in accordance with the manual
Note: The booster heaters fill automatically when the doors are closed. The
machine has a filling check function for the booster heaters. When the func-
tion is activated, a check is carried out to ensure that the booster heaters
are full of water, before the element is switched on.
NB! If the filling is cancelled, the filling check will be restarted by the booster
heater from zero.
•
When the filling check has been completed and all the tanks are full, the
mini-switches for the booster heaters switch on
3. Check the setting of the reference values
•
All the reference values have been set to the recommended values on de-
livery
•
Check that the motor cut-off switch for the infeed and outfeed conveyors
have been set correctly
WD-215T
17
Rev. 6.0 (201812)
Advertisement
Table of Contents
