Operating instructions
4.1.3 Filling and heating the machine
Machines without a drain pump
•
•
•
•
•
Machines with a drain pump (option)
•
•
•
•
WD-6C
Turn the knob (8) to position (6).
Close the hood. The machine will now automatically fill with water. The
indicator light (2) will come on and will show green once the correct water
level has been reached.
The booster heater begins heating the water immediately and continues
until the water has reached the correct temperature (85°C), (see
thermometer (5)). The water is subsequently heated in the tank as
required.
The heating time is dependent on the incoming water temperature.
Before washing commences, check on the thermometer (3) that the water
temperature has reached 60°C and on the thermometer (5) that the final
rinse temperature has reached 85° C.
Turn the knob (7) to position (6).
Close the hood. The machine will now automatically fill with water. The
indicator light (2) will come on and will show green once the correct water
level has been reached.
The booster heater begins heating the water immediately and continues
until the water has reached the correct temperature (85°C), (see
thermometer (5)). The water is subsequently heated in the tank as
required.
The heating time is dependent on the incoming water temperature. Before
washing commences, check on the thermometer (3) that the water
temperature has reached 60°C and on the thermometer (5) that the final
rinse temperature has reached 85° C.
28
Rev. 7.0 (202202)