Table of Contents
Advertisement
Instructions for use
ALARM MESSAGE
(31)
TIMEOUT HEATING
TANKS AND BOILERS
PRESS RESET
(33)
DOOR IS OPEN
CLOSE DOOR
(41)
LOW LEVEL IN TANK 2
(CHEM WASH TANK 1)
(51) OVERLOAD
FEEDING ACTIVATED
REMOVE OBJECT
RESTART FEEDING
(85)
OVERLOAD FEEDING
ACTIVATED
PRESS RESET
(52) FEEDER LIMIT
SWITCH ACTIVATED.
REMOVE OBJECT FROM
THE FEEDER LIMIT
(54) TRAY DISPENSER
OUT OF POSITION
CHECK
TRAY DISPENSER
(61)
LOW TEMPERATURE
IN TANK 2
(CHEM WASH TANK 1)
(62)
LOW TEMPERATURE
IN TANK 3
(CHEM WASH TANK 2)
(81)
LOW TEMPERATURE
IN TANK 4
(CHEM WASH TANK 3)
(66)
LOW TEMPERATURE
IN THE FINAL RINSE
BOILER
(71) WASHING DETER-
GENT ALARM ACTIVE
CHECK DETERGENT
DEVICE
(77)
FINAL RINSE ERROR
SENSOR ERROR
FLOW METER BV02
(76)
FINAL RINSE ERROR
NO FLOW IN
THE MACHINE
WD-215T
ACTION
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Close the door and start the feed by pressing button (5).
Close the level pipe or the outlet seal. Check the rubber sleeve.
Remove the item. Start the feed by pressing button (5).
Reset the alarm by pressing button (9).
Remove the basket. The feed will start automatically.
Adjust the dispenser if it is in the wrong position or connect an empty dispenser
to the machine or tray exchanger.
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Check and fill with new detergent.
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
Check that the stopcocks on the incoming water supply are open. Reset the
alarm by pressing button (9). If the error recurs, contact an authorised service
company.
44
Rev. 6.0 (201812)
Advertisement
Table of Contents
