Table of Contents
Advertisement
Instructions for use
4.2.3 Storage in the tray dispenser
If washed trays are stored in the tray dispenser connected to the machine's out-
feed end, a message will appear on the display when the dispenser is full of trays.
Change the dispenser. When an empty dispenser is put in place, the machine is
ready to wash again.
The machine can also be connected to a tray exchanger for two dispensers.
When one dispenser is full, the trays are automatically switched to the other dis-
penser and the machine does not stop until both dispensers are full.
4.2.4 Changing the water
For best wash results, it is important that the water in the tanks is changed if it
becomes too dirty. The water should always be changed if foam begins to form in
the chemical wash tank.
•
•
•
•
4.2.5 Emergency stop
The machine will go to an emergency stop if button (11) on the control panel is
pressed. If an emergency stop occurs:
•
•
•
4.2.6 Unloading trays manually
Manual unloading is used to empty the machine of trays. When the last trays need
to be washed and the machine has stopped, use the manual unloading mode to
take the remaining trays out of the machine.
Unload the trays by pressing the button (4).
WD-215T
Switch the machine off by pressing button (10).
Remove the filters (19) and empty the machine by turning the level pipe
(22) a quarter of a turn.
When the tank is empty, close the level pipe and refit the filters.
Refill the machine with water.
The problem which caused the emergency stop must be rectified.
Reset the emergency stop by turning it in the direction of the arrows (clock-
wise).
Reset the alarm by pressing button (5).
36
Rev. 6.0 (201812)
Advertisement
Table of Contents
