Table of Contents
Advertisement
Installation instructions
3.5.1 Power supply
Information about electrical connections is available on the machine's wiring dia-
gram which is provided on delivery. Store the diagrams in the plastic pocket, loca-
ted in the electrical cabinet, even after installation.
•
•
•
After completing the installation, switch on the main switch and all circuit brea-
kers.
3.5.2 Water
•
•
The water pipe is connected at (2, or alternatively 9) or at (3, or alternatively 10).
If the machine is connected with a hose, this should be steel braided and have an
internal diameter of at least 12 mm.
The hot water connection on the machine is fitted with a filter.
The cold water connection on the machine is fitted with a filter, non-return valve
and vacuum valve.
As the machine is fitted with a "Break Tank", the connection is fitted with a filter.
3.5.3 Ventilation
The machine's heat load for the room is stipulated in TECHNICAL SPECIFICA-
TIONS.
The machine has a condensing battery connected to an exhaust fan to reduce the
amount of steam released. Extractor fans for extracting steam can be installed
above the infeed and outfeed openings, as well as above the area of the machine
where steam is emitted from the condensing fan.
If a hood is fitted over the machine, it much be positioned so that it covers the dry-
ing rack after the machine and preferably also the exhaust from the condensing
fan.
WD-215T
The machine is designed for quick electrical installation.
The machine has a built-in main switch. Connect the electric cable at (1).
In special cases, certain dishwashers may have an electrical connection
from the floor. The cable is then drawn behind the cover plate and through
the channelling at (8).
Check the direction of rotation of the pump motors during operation when
the tanks are full of water. The direction of rotation must conform without
exception to the direction of the arrow on the pump. Stop the dishwasher
immediately if the direction of rotation is incorrect and change two of the
incoming phases.
A shut-off cock must be installed on the incoming pipe.
It is important that the water supply has sufficient pressure to ensure the
correct flow of water to the machine. The required water flow and pressure
can be found in the TECHNICAL SPECIFICATIONS. If the water pressure
is too low, a booster pump must be fitted.
13
Rev. 6.0 (201812)
Advertisement
Table of Contents
