Table of Contents
Advertisement
Instructions for use
4.3.2 Daily cleaning
Internally
•
•
•
•
•
•
•
•
•
•
•
Cleaning the filter
The final rinse tank must be empty when the filter (25) is cleaned otherwise water
will leak into the dish-washing room when the filter is unscrewed. The tank must
be emptied in connection with daily cleaning.
•
•
•
•
WD-215T
Unhook the curtains (17) at the infeed end and wash them in a basket.
Switch the machine off by pressing button (10).
Empty the tank by turning the level pipe (22) a quarter of a turn.
Clean the filters (19), the curtains (17), the level pipe (22), the outlet seals
(24) and the rinse nozzles (15). Never leave the level pipe so that the rub-
ber sleeve rests on a surface. The sleeve can become deformed leading to
the risk of water leakage in the tank.
Clean the washer arm nozzles (16).
Clean the doors (23). Wipe the rubber strips on the doors which are fitted
at the top of the back of the doors. Always leave the doors open after cle-
aning the machine.
Rinse out all of the machine's inside surfaces and clean the tank.
Finally, clean the filter (26).
Empty the final rinse tank and clean the filter (25). The filter is placed be-
hind the lower door at the outfeed end.
Refit the components.
Leave the doors open.
Unscrew the cover (C) and remove the filter (B). Rinse the filter and cover.
When refitting, it is important to fit the filter correctly to ensure that it is not
damaged and that no leakage occurs.
First fit the filter (B) in the filter housing (A) then ensure that it is sitting
straight.
Fit the cover (C), (does not need to be screwed tight).
38
Rev. 6.0 (201812)
Advertisement
Table of Contents
