Where To Go From Here - Meru Networks AP300 Installation Manual

AP150 LED Descriptions
LED
Power
Radio I
Radio II
Ethernet

Where to Go From Here

Now that the AP150 is installed, go to the Meru System Director Getting Started
Guide for instructions on initializing the hardware. Return to this chapter to check
the status of the LEDs once the WLAN is operational.
© 2010 Meru Networks, Inc.
Function
The Power status LED status is as follows:
off—power is off

solid red—when power is applied, system initializes for 40 seconds and then

the LED turns amber; after discovering the controller the LED turns green.
Otherwise, the system is in an abnormal state (notify Customer Support).
solid amber—at any time, if this LED state persists longer than 40 seconds,

notify Customer Support
solid green—system is fully operational

The Radio I LED is lit when radio packets are being transmitted and when
the radio is beaconing.
The Radio II LED is lit when radio packets are being transmitted and
when the radio is beaconing.
The Ethernet LED status is as follows:
off—no link

solid green—100Mbps connection

blinking green—transmit or receive activity at 100Mbps

solid amber—10Mbps connection

blinking amber—transmit or receive activity at 10Mbps

Where to Go From Here
Installing AP150 85