Test Basic Link Operation; Mounting The Access Point - Meru Networks AP300 Installation Manual

Test Basic Link Operation

Set up the OAP180 on the ground, either outdoors or indoors. Connect the unit as
indicated in this document and perform the basic configuration tasks outlined below.
When you are satisfied that the OAP180 is operating correctly, proceed to mounting
the unit in the intended location.

Mounting the Access Point

The OAP180 can be mounted on the following (brackets are included):
2 to 3 inch diameter pole

Wall

Mounting OAP180 with the Pole-Mounting Bracket
Be sure to attach antennas (see
before mounting an OAP180 on a pole. Follow these steps to mount the unit to a 2 to
3 inch diameter steel pole or tube using the mounting bracket:
1. Attach the OAP180 to the mounting bracket.
Figure 36: Square Mounting Bracket Attaches to Bottom of OAP180
2. Place the V-shaped part of the bracket around the pole and tighten the securing
Note:
grooves facing up.
© 2010 Meru Networks, Inc.
Attach the adjustable
rectangular plate to
the bridge with
supplied screws
nuts just enough to hold the bracket to the pole. (The bracket may need to be
rotated around the pole during the alignment process.)
Always attach the bracket to a pole with the open end of the mounting
Connect Antennas and Ground Wire to
Installing the Access Points
OAP180)
Installing OAP180 91