Meru Networks AP300 Installation Manual page 106

Installing the Access Points
Figure 37: Brackets Attached to a Pole
Attach the bridge
with bracket to
affixed plate on pole
3. Use the included nuts to tightly secure the wireless OAP180 to the bracket.
4. Connect the
Mounting OAP180 with the Wall-Mounting Bracket
Attach the bracket to a wall with the flat side flush against the wall. Follow these
steps to mount the unit to a wall using the wall-mounting bracket:
1. Position the bracket in the intended location and mark the position of the four
2. Drill holes in the wall that match the screws and wall plugs included in the
Figure 38: Mount OAP180 Bracket on Wall
3. Use the included nuts to tightly secure the OAP180 to the bracket.
4. Connect the two brackets as shown below.
92 Meru Access Point Installation Guide
bracket and the pole bracket.
OAP180
mounting screw holes.
bracket kit, and then secure the bracket to the wall.
© 2010 Meru Networks, Inc.