Installing The Access Points; Selecting A Location - Meru Networks AP300 Installation Manual

Installing the Access Points

AP200 Installation Tools
Installation Type
Horizontal mounting
Vertical mounting over a wall stud
Vertical mounting on sheetrock
Horizontal mounting below a hanging ceiling
Mounting above a hanging ceiling (AP200 metal
enclosure only)
Installing the Access Points

Selecting a Location

The AP200 requires a location that meets the following:
Relatively unobstructed access to the stations the AP serves

Power over Ethernet (PoE) connection to the network switch servicing the

controller.
APs can obtain their power from 802.3af st andard Power over Ethernet (PoE)-compat-
ible network switch or PoE power injector installed between the switch and the
AP200.
Select a location with minimal physical obstructions between the AP and the wireless
stations. In an office with cubicles, mounting the APs below a hanging ceiling or the
wall near the ceiling provides the least obstructed communications path. For an
external power supply connection, ensure the power source is near to where the
AP200 will be mounted.
Most installations receive the best coverage using the following guidelines:
Install APs toward the center of the building.
56 Meru Access Point Installation Guide
Tools Required
None
Drill

1/8"drill bit

Screwdriver

Drill

3/16" drill bit

Screwdriver

Screwdriver

Wrench or pliers

Wrench or pliers

Screwdriver

© 2010 Meru Networks, Inc.