Meru Networks AP300 Installation Manual page 96

Installing the Access Points
Note:
to attach the AP150 to the mounting bracket.
Figure 32: Mounting the AP150 to a Suspended Ceiling Rail
To mount an AP150 below a suspended ceiling:
1. Using a 1/8" Allen wrench, remove the shoulder screws from the mounting
2. Determine the location on the ceiling rail where the AP will be mounted and
3. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to
4. Adjust the distance between the caddy fasteners by using the mounting bracket
5. Tighten the caddy fasteners in place using a standard screwdriver. Do not
6. Place each spacer on the caddy fastener stud. The spacer legs should contact the
7. Align the mounting bracket keyholes with the caddy fastener studs and slide the
8. Attach a keps nut to each caddy fastener stud and hand tighten. Do not
9. Align the AP150 with the bracket thumbscrews (see
82 Meru Access Point Installation Guide
To comply with NEC code, attach a grounding wire to any of the screws used
Washers
bracket, if already attached.
remove the ceiling tiles.
the rail.
holes as a guide.
overtighten.
ceiling T-rail.
AP150 to the narrow end of the hole.
overtighten.
thumbscrews to attach the bracket.
Suspended ceiling T-rail
Caddy fastener(s)
Spacer(s)
Mounting bracket
Figure 31) and tighten the
© 2010 Meru Networks, Inc.