Meru Networks AP300 Installation Manual page 128

Canada. Industry Canada (IC)
Caution!
Note:
Access Points have been designed to operate with the antennas listed below. Antennas not
included in this list are strictly prohibited for use with these devices. The required antenna
impedance is 50 ohms.
AP Antennas with Gain
AP Model
AP300
AP300
AP300
AP200
AP200
AP150
To reduce potential radio interference to other users, the antenna type and its gain should be
chosen so that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
114 Meru Access Point Installation Guide
Exposure to Radio Frequency Radiation.
The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit an RF field in excess of Health Canada limits
for the general population; consult Safety Code 6, obtainable from Health
Canada's website http://www.hc-sc.gc.ca/rpb.
This equipment complies with IC RSS-102 radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20cm between the antennas and any persons/users
in the vicinity.
Meru Access Points
These devices are restricted to indoor use because they operate in the 5.15 to
5.25 GHz frequency range. Industry Canada requires such products to be used
indoors for the frequency range 5.15 GHz to 5.25 GHz to reduce the potential
for harmful interference to co-channel Mobile Satellite systems.
Antenna Type
Dual-Band Omni-Directional
MN-ACC-ANTabg-W
Dual-Band Omni-Directional
ACC-ANT-ABGN-23
High-Gain Dipole Omni-Directional
ACC-ANT-ABGN47O
Dual-Band Omni-Directional
SAA04-220050
Dual-Band Omni-Directional
TWX-614XRSXX
Dual-Band Omni-Directional
SAA04-220050
Gain (2.4 GHz) Gain (5 GHz)
2 dBi 3 dBi
2 dBi 3 dBi
4.7dBi 4.7dBi
2 dBi 3 dBi
4 dBi 5 dBi
2 dBi 3 dBi
© 2010 Meru Networks, Inc.