Meru Networks AP300 Installation Manual page 72

Installing the Access Points
Figure 16: AP200 Antenna Connection
Antenna
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Note:
Caution!
mistakenly be plugged into the Console port (see
58 Meru Access Point Installation Guide
Turn clockwise
to tighten
connector, shown in Figure
For the AP201 and AP208 access points, a shielded Cat 5e (or greater)
Ethernet cable must be used in order to comply with international
electromagnetic emissions limits.
If it is not practical to use shielded cables, contact Support for a line filter,
available at no charge, that may also be used to ensure compliance.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
(Reserved)
Console
Antenna 1
port
CONSOLE
ANT 1
17.
Figure
Reset
100/1000
(Push to restore
Ethernet
default settings)
ETHERNET
17).
(Currently
unsupported)
Power Antenna 2
inlet
3.3 VDC
ANT 2
© 2010 Meru Networks, Inc.