Meru Networks AP300 Installation Manual page 91

Horizontal Mounting
To horizontally mount an AP150:
1. Place the AP150 flat on the horizontal surface.
2. For each antenna, loosen the knurled ring at the base of the antenna (see
Figure 28: AP150 Antenna Connection
Antenna
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Figure 29: AP150 Connector Panel
Vertical Mounting the AP150
To perform a simple wall mount using the keyholes on the back of the AP150:
1. Remove the attached mounting bracket from the back of the AP150.
© 2010 Meru Networks, Inc.
Figure 28), point the antenna straight up, then retighten the ring.
Turn clockwise
to tighten
connector, shown in Figure
Antenna 1
Power Ethernet
(reserved)
connection
ANT1
DC 5V
LAN
29.
Console
port
Reset Reload
(reserved)
button
RESET RELOAD
CONSOLE
Installing the Access Points
Antenna 2
ANT2
Installing AP150 77