Checking Led Activity - Meru Networks AP300 Installation Manual

Checking LED Activity

Check the OAP180 LEDs for activity. Four of the eight LEDs on the bottom of the
OAP180 indicate activity; four LEDs are not used at this time. Check the four active
LEDs to determine if the AP is working.
Figure 43: OAP180 LEDs
These 4 LEDs
are not used
The grey LEDs in the illustration are not currently used. The following chart explains
the meanings for the remaining LEDs.
LED
Power
Radio 1
802.11bg
Radio 2
802.11a
Ethernet
© 2010 Meru Networks, Inc.
Console PoE
Power On
LED
Ethernet link
LED
Transmission LEDs
(radio packets transmitting)
Function
When power is applied, this LED initially turns amber , then blinks green
when the system power check is applied, and then is a steady green
when power is on.
The 11bg connection LED blinks amber when radio packets are being
transmitted and when the radio is beaconing. If there is traffic over the
air on this radio, the blinking rate increases.
The 11a connection LED blinks green when radio packets are being
transmitted and when the radio is beaconing. If there is traffic over the
air on this radio, the blinking rate increases.
The Ethernet Link LED blinks green when a link has been detected and
is in use.
Checking LED Activity
Installing OAP180 97