Align Antenna - Meru Networks AP300 Installation Manual

Installing the Access Points
Figure 42: Connect OAP180 to Power Injector
Ethernet cable
from LAN switch
2. Connect a straight-through unshielded twisted-pair (UTP) cable (not included)
Note:
a computer for testing the link, use a crossover cable.
3. Insert the power cable plug directly into the standard AC receptacle on the power
4. Plug the other end of the power cable into a grounded, 3-pin socket, AC power
Note:
a line cord set that has been approved for the receptacle type in your country.
5. Check the LED on top of the power injector to be sure that power is being supp lied

Align Antenna

After the OAP180 unit is mounted, connected, and the radios are operating, the
antennas must be accurately aligned to ensure optimum performance of the OAP180
links. In this point-to-multipoint configuration all OAP180 nodes must be aligned
with the root OAP180 antenna.
96 Meru Access Point Installation Guide
from a local LAN switch to the RJ-45 port labeled Input on the power injector. See
the illustration above. Use Category 5e or better UTP cable for 10/100BASE-TX
connections.
The RJ-45 port on the power injector is an MDI port. If connecting directly to
injector. See the illustration above.
source.
For International use, you may need to change the AC line cord. You must use
to the OAP180 through the Ethernet connection.
Power LED indicator
Ethernet cable to
wireless bridge
AC power
© 2010 Meru Networks, Inc.