Checking Led Activity; Figure 9 Ap100-P Installed Above Ceiling Tile; Figure 10 Rj-45 Leds - Meru Networks AP100 Installation Manual

Checking LED Activity

12.
13.
The AP100-P, with mounting bracket and light-pipe extender, installed above a ceiling tile is shown
in Figure
Side view
Mounting bracket
Access Point
Ceiling tile
Figure 9: AP100-P Installed Above Ceiling Tile
Checking LED Activity
After the AP100 is connected, the LEDs near the RJ-45 connector should light, as shown in
Figure 10: RJ-45 LEDs
The green LED on the left blinks if any Ethernet activity is taking place. If there is no Ethernet activity,
the LED is off. The LED on the right is solid yellow if an Ethernet link is present. If no Ethernet link
is present or connectivity is lost, the LED is off.
14 Installing the Meru Air Point 100
If needed, reposition the antennas. Be sure to loosen the ring at the base of the antenna before
repositioning, and retighten after.
Replace the ceiling tile in the ceiling brackets.
9:
Link present
Ethernet activity
Light pipe extender
Figure 10.