Mounting The Access Point; Figure 5 Attaching An Antenna To The Ap100; Figure 6 Attaching The Ethernet Cable To The Ap100 - Meru Networks AP100 Installation Manual

Installing the Access Point
Antenna
Figure 5: Attaching an Antenna to the AP100
Caution!
before moving the antenna. Retighten the ring afterward. Otherwise, you might damage the internal
cabling in the AP.

Mounting the Access Point

You can mount the access point in the following ways:
Horizontally, as described in the
Vertically, as described in the
Below a ceiling, as described in the
Above a ceiling tile, as described in the
Horizontal Mounting
To horizontally mount an AP100:
1.
2.
3.
Figure 6: Attaching the Ethernet Cable to the AP100
10 Installing the Meru Air Point 100
Access Point 100
Turn clockwise
to tighten
When changing the orientation of the antennas, be sure to slightly loosen the knurled ring
Place the AP flat on the horizontal surface.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight up, then retighten the ring.
Connect the PoE 100BaseT Ethernet cable, as shown in
Ethernet cable
"Horizontal Mounting"
"Vertical Mounting" section.
"Mounting Below a Ceiling"
"Mounting Above a Suspended Ceiling"
section.
section.
Figure 5), point the
Figure 6.
section.