Mobile wireless settings
Communication using mobile wireless networks is not supported.
3.6.1.3
Transmission settings
You will find the specific parameters of the telecontrol protocol in the section DNP3
parameters of the interfaces (Page 53).
3.7
Configuring WAN networks
Parameters of classic WAN networks
If you first configure the "WAN settings" parameter group of the communications module
interfaces, the most important settings of the interface are taken from the connected WAN
network when a new network is generated.
The classic WAN networks, shown in blue in STEP 7, have the following parameter groups.
General
Like for any other network, this is where you configure the name and the S7 subnet ID.
Network settings
Network configuration
● Protocol type
The following telecontrol protocols are available:
– ST7
– DNP3
– IEC 60870
● Network type
The network type is taken from the connected interface:
– Dedicated line
– Dialup network
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
(see above) is lost. This mode is primarily intended for control systems that archive
events strictly chronologically.
Configuration
3.7 Configuring WAN networks
51